پیوندهای مفید
اخبار و اعلانات
آمار
| تعداد نشریات | 11 |
| تعداد شماره‌ها | 210 |
| تعداد مقالات | 2,101 |
| تعداد مشاهده مقاله | 2,884,051 |
| تعداد دریافت فایل اصل مقاله | 2,091,225 |
Application of linear and nonlinear vibration absorbers for the nonlinear beam under moving load | ||
| Journal of Computational & Applied Research in Mechanical Engineering (JCARME) | ||
| مقاله 5، دوره 5، شماره 1، اسفند 2015، صفحه 51-60 اصل مقاله (816.99 K) | ||
| نوع مقاله: Research Paper | ||
| شناسه دیجیتال (DOI): 10.22061/jcarme.2015.344 | ||
| نویسندگان | ||
| Nadia Parandeh Afshar1؛ Farhad S. Samani* 2؛ Moslem Molaie1 | ||
| 1M. Sc. student in mechanical engineering, Shahid Bahonar University of Kerman, Iran | ||
| 2Assistant professor, Department of Mechanical Engineering, Shahid Bahonar University of Kerman, Iran | ||
| تاریخ دریافت: 23 دی 1393، تاریخ بازنگری: 24 فروردین 1394، تاریخ پذیرش: 06 اردیبهشت 1394 | ||
| چکیده | ||
| Recently, a large amount of studies have been related to nonlinear systems with multi-degrees of freedom as well as continuous systems. The purpose of this paper is to optimize passive vibration absorbers in linear and nonlinear states for an Euler-Bernoulli beam with a nonlinear vibratory behavior under concentrated moving load. The goal parameter in the optimization is maximum deflection of the beam. The large deformation for beam modeling is considered, i.e. the relation between strains and deflections is nonlinear. The force magnitude and beam length are two effective factors for the beam deflection. Vibration absorber with linear damping and linear or nonlinear stiffness is also considered in this manuscript. The results show that, for normal forces and short beams, linear and nonlinear models have similar behaviors, while surveying nonlinear behavior is necessary by increasing the force and length of the beam, i.e. large deflections. Moreover, the difference between linear and nonlinear beam models for regular force magnitudes and beam lengths is negligible. For higher loads and longer beams, beam model nonlinearity can be important. Results demonstrate that,in the presented numerical values (train bridge application) for cubic nonlinear vibration absorber, there are two optimal locations for vibration absorber installation: one inclined from the middle of the beam to the direction of moving loads and the second which is more interestingly inclined from the middle of the beam to moving loads in the opposite direction. Moreover, depending on the model's numerical parameters, for short beams, linear vibration absorber is more effective, while for long beams, cubic nonlinear beam behaves better than the linear one. | ||
| کلیدواژه‌ها | ||
| Nonlinear beam model؛ Moving load؛ Nonlinear vibration absorber | ||
| مراجع | ||
|
[1] P. Timoshenko, “On the forced vibrations of bridges”, Philosophical Magazine, Ser. 6, Vol. 43, Issue. 257, pp. 1018-1019, (1922).
[2] H. Jeffcott, “On the vibration of beams under the action of moving loads”, Philosophical Magazine, Ser. 7, Vol. 8, Issue. 48, pp. 66-97, (1929).
[3] N. Lowan, “On transverse oscillations of beams under the action of moving variable loads”, Philosophical Magazine, Ser. 7, Vol. 19, Issue. 127, pp. 708-715, (1935).
[4] M. Biggs, “Introduction to structural dynamics”, McGraw-Hill, New York, (1964).
[5] Fryba, “Vibration of solids and structures under moving loads”, Noordhoff international publishing, Groningen, the Netherlands, Vol. 53, Issue. 7, pp. 502-503, (1972).
[6] B. Warburton, “The dynamical behavior of structures”, Pergamon, Oxford, (1976).
[7] M. Stanisic, “On a new theory of the dynamic behavior of the structures carrying moving masses”, Ingenieur-Archive, Vol. 55, Issue. 3, pp. 176-185, (1985).
[8] Sadiku, and H. H. E. Leipholz, “On the dynamics of elastic systems with moving concentrated masses”, Ingenieur-Archive, Vol. 57, Issue. 3, pp. 223-242, (1987).
[9] E. Akin, and M. Mofid, “Numerical solution for response of beams with moving mass”, J. Struct. Engng, ASCE, Vol. 115, Issue. 1, pp. 120-131, (1989).
[10] H. Chu, V. K. Garg, and T. L. Wang, “Impact in railway pre-stressed concrete bridges”, J. Struct. Engng, ASCE, Vol. 112, Issue. 5, pp. 1036-1051, (1986).
[11] B. Yang, S. S. Liao, and B. H. Lin, “Impact formulas for vehicles moving over simple and continuous beams”, Journal of Structural Engineering, ASCE , Vol. 121, Issue. 11, pp. 1644-1650, (1995).
[12] V. Nishawala, A study of large deflection of beams and plates, [MSc thesis], New Brunswick, Rutgers, The state university of New Jersey, (2011).
[13] S. Samani, F. Pellicano, “Vibration reduction on beams subjected to moving loads using linear and nonlinear dynamic absorbers”, Journal of Sound and Vibration, Vol. 325, Issue. 4-5, pp. 742–754, (2009).
[14] S. Samani, F. Pellicano, “Vibration reduction of beams under successive traveling loads by means of linear and nonlinear dynamic absorbers”, Journal of Sound and Vibration, Vol. 331, Issue. 10, pp. 2272–2290, (2012).
[15] Savin, “Dynamic amplification factor and response spectrum for the evaluation of vibrations of beams under successive moving loads”, Journal of sound and vibration, Vol. 248, Issue. 2, pp. 267-288, (2001). | ||
|
آمار تعداد مشاهده مقاله: 2,426 تعداد دریافت فایل اصل مقاله: 2,018 |
||