Effect of concentric and eccentric porous layers on forced convection heat transfer and fluid flow around a solid cylinder

Alinezhad, Alireza; Soltani Goharrizi, Ataallah; Kamyabi, Ataallah

doi:10.22061/jcarme.2024.8784.2182

تعداد نشریات	13
تعداد شماره‌ها	238
تعداد مقالات	2,418
تعداد مشاهده مقاله	3,962,370
تعداد دریافت فایل اصل مقاله	2,874,087

	Effect of concentric and eccentric porous layers on forced convection heat transfer and fluid flow around a solid cylinder
Journal of Computational & Applied Research in Mechanical Engineering (JCARME)
مقاله 6، دوره 13، شماره 2 - شماره پیاپی 26، فروردین 2024، صفحه 191-206 اصل مقاله (1.43 M)
نوع مقاله: Research Paper
شناسه دیجیتال (DOI): 10.22061/jcarme.2024.8784.2182
نویسندگان
Alireza Alinezhad؛ Ataallah Soltani Goharrizi^* ؛ Ataallah Kamyabi
Department of Chemical Engineering, Faculty of Engineering, Shahid Bahonar University of Kerman, Kerman, 7618868366, Iran
تاریخ دریافت: 05 بهمن 1400، تاریخ بازنگری: 30 دی 1402، تاریخ پذیرش: 07 بهمن 1402
چکیده
In this paper, heat transfer and fluid flow around a solid cylinder wrapped with a porous layer in the channel were studied numerically by computational fluid dynamics. The homogeneous concentric and eccentric porous medium around a rigid and solid cylinder is supposed at local thermal equilibrium. The transport phenomena within the porous layer and volume-averaged equations were employed; however, the conservation laws of mass, momentum and energy were applied in the channel. The main purpose of this study is to analyze and compare the heat flux of concentric and eccentric porous layer in the Reynolds number range of 1 to 40 and Darcy numbers of 10^-2 to 10^-6. It is found that with the decline of Darcy number, the vortex length is increased behind the solid cylinder surface. In addition, the heat flux rate of the cylinder is raised with the increase of Reynolds number. Finally, the results showed that the average Nusselt numbers in different Darcy and Reynolds numbers are higher in the eccentric porous layer than in the concentric porous layer. For example, our findings show that in , and , the average Nusselt number in the eccentric porous layer is higher than the concentric porous layer.
کلیدواژه‌ها
Porous media؛ Darcy number؛ Volume averaged equation؛ Eccentricity؛ Cross-flow

مراجع
[1] S. Bhattacharyya, S. Dhinakaran, and A. Khalili, “Fluid motion around and through a porous cylinder,” Chem. Eng. Sci, Vol. 61, No. 13, pp.44514461,(2006). [2] S. Bhattacharyya, and A. K. Singh, “Augmentation of heat transfer from a solid cylinder wrapped with a porous layer,” Int. J. Heat Mass Transfer, Vol. 52, No. 7-8, pp.19912001,(2009). [3] S. Rashidi, A. Tamayol, M. S. Valipour, and N. Shokri, “Fluid flow and forced convection heat transfer around a solid cylinder wrapped with a porous ring,” Int. J. Heat Mass Transfer, Vol. 63, No. 5, pp. 91100,(2013). [4] A. Alinezhad, M. Khatibi, S.N. Ashrafizadeh, “Impact of asymmetry soft layers and ion partitioning on ionic current rectification in bipolar nanochannels,” J. Mol. Liq, Vol. 347, No. 3, pp. 118324, (2022). [5] A. Alinezhad and A. Alinezhad, “Influence of location junction on ion transfer behavior in conical nanopores with bipolar polyelectrolyte brushes,” Electrochimica. Acta, Vol. 425, No. 2, pp.140699,(2022). [6] A. Alinezhad, M. Khatibi, S.N. Ashrafizadeh,“ Ionic transfer behavior of bipolar nanochannels resembling PNP nanotransistor,” Electrochimica. Acta, Vol. 460, No. 2, pp. 142625,(2023). [7] D. K. Baghel, S. L. Sinha, and S. K. Dewangan, “SST K-ω based air flow and heat transfer assessment in an infant incubator,” JCARME, Vol. 12, No. 2, pp. 161-175, (2023). [8] S. M. M. Madani, J. Alinejad, Y. Rostamiyan, and K. Fallah, “Lattice Boltzmann simulation inside a cavity: The effect of pipe profile on natural convection,” JCARME, Vol. 13, No. 1, pp. 67-74, (2023). [9] M. Sadegh Valipour, and A. Zare Ghadi, “Numerical investigation of forced convective heat transfer around and through a porous circular cylinder with internal heat generation,” J. Heat Transfer, Vol. 134, No. 6, (2012). [10] F. M. Rong, Z. L. Guo, J. H. Lu, and B. C. Shi, “Numerical simulation of the flow around a porous covering square cylinder in a channel via lattice Boltzmann method,” Int. J. Numer. Methods Fluids, Vol. 65, No. 10, pp. 1217-1230,(2011). [11] N. Alvandifar, M. Saffar-Avval, and E. Amani, “Partially metal foam wrapped tube bundle as a novel generation of air cooled heat exchangers,” Int. J. Heat Mass Transfer, Vol. 118, No. 2, pp. 171-181, (2018). [12] M. Odabaee, K. Hooman, and H. Gurgenci, “Metal foam heat exchangers for heat transfer augmentation from a cylinder in cross-flow,” Transp. Porous Media, Vol. 86, No. 3, pp. 911-923, (2011). [13] N. Rahmati, Z. Mansoori, M. Saffar-Avval, and G. Ahmadi, "Numerical Study of Heat Transfer in Turbulent Cross-Flow Over Porous-Coated Cylinder." J. Fluids Eng, Vol. 58042, No. 4, pp.V01AT04A014,(2017). [14] M. A. Saada, S. Chikh, and A. Campo, “Natural convection around a horizontal solid cylinder wrapped with a layer of fibrous or porous material,” Int. J. Heat Fluid Flow, Vol. 28, No. 3, pp.483-495,(2007). [15] G. F. Al-Sumaily, A. Nakayama, J. Sheridan, and M. C. Thompson, “The effect of porous media particle size on forced convection from a circular cylinder without assuming local thermal equilibrium between phases,” Int. J. Heat Mass Transfer, Vol. 55, No. 13-14, pp. 3366-3378,(2012). [16] M. H. J. Pedras, and M. J. S. de Lemos, “Macroscopic turbulence modeling for incompressible flow through undeformable porous media,” Int. J. Heat Mass Transfer, Vol. 44, No. 6, pp. 1081-1093, (2001). [17] K. Chen, L. Guo, X. Xie, and W. Liu, “Experimental investigation on enhanced thermal performance of staggered tube bundles wrapped with metallic foam,” Int. J. Heat Mass Transfer, Vol. 122, No. 3, pp.459468,(2018). [18] K. Al-Salem, H. F. Oztop, and S. Kiwan, “Effects of porosity and thickness of porous sheets on heat transfer enhancement in a cross flow over heated cylinder,” I Int. Commun. Heat Mass Transfer, Vol. 38, No. 9, pp. 1279-1282, (2011) [19] V. V. Calmidi, and R. L. Mahajan, “Forced convection in high porosity metal foams,” J. Heat Transfer, Vol. 122, No. 3, pp. 557-565, (2000). [20] C. Y. Zhao, T. Kim, T. J. Lu, and H. P. Hodson, “Thermal transport in high porosity cellular metal foams,” J. Thermophys. Heat Transfer, Vol. 18, No. 3, pp. 309-317, (2004). [21] E. Ebrahimi, Y. Amini, and G. Imani, “Heat transfer characteristics of a circular cylinder covered by a porous layer undergoing vortex-induced vibration,” Int. J. Therm, Vol. 166, No. 2, pp. 106974,(2021). [22] M. Mehdi Keshtkar, and M. Dadkhodazadeh, “Thermal simulation of the symmetric and asymmetric arrangement of barriers on heat transfer enhancement in a porous gas heat exchanger,” J. Therm. Sci. Eng. Appl, Vol.10, No. 5, pp. 051001, (2018). [23] Y. Kaptan, E. Buyruk, and A. Ecder, “Numerical investigation of fouling on cross-flow heat exchanger tubes with conjugated heat transfer approach,” Int. Commun. Heat Mass Transfer, Vol. 35, No. 9, pp. 11531158,(2008). [24] Y. J. Zhuang, H. Z. Yu, and Q. Y. Zhu, “Experimental and numerical investigations on the flow around and through the fractal soft rocks with water vapor absorption,” Int. J. Heat Mass Transfer, Vol. 96, No. 3, pp. 413-429, (2016). [25] H. Kaydani, and A. Mohebbi, “Experimental and numerical study of the onset of transient natural convection in a fractured porous medium,” Transp. Porous Media, Vol. 116, No. 2, pp. 923-939, (2017). [26] Liu, X., D. Toghraie, M. Hekmatifar, O. A. Akbari, A. Karimipour and M. Afrand, “Numerical Investigation of Nanofluid Laminar Forced Convection Heat Transfer between Two Horizontal Concentric Cylinders in the Presence of Porous Medium,” J. Therm. Anal. Calorim, Vol. 141, No. 3, pp. 2095-2108, (2020).
آمار تعداد مشاهده مقاله: 522 تعداد دریافت فایل اصل مقاله: 621

سامانه مدیریت نشریات علمی. طراحی و پیاده سازی از سیناوب

پیوندهای مفید

آمار

Effect of concentric and eccentric porous layers on forced convection heat transfer and fluid flow around a solid cylinder